herpy
Topics

Heat and temperature

How to give reptiles and amphibians the right heat: temperature gradient, basking spot, night-time drop, heat sources, thermostats and measuring equipment, and how to avoid overheating and fire. For everyone who is setting up or upgrading a terrarium.

A temperature gradient instead of a single temperature

Reptiles and amphibians are ectothermic. They produce almost no heat themselves and regulate body temperature by moving between warm and cool places. A terrarium should therefore not have a single temperature but a gradient: a warm end, a cool end and every step in between. The animal chooses where it wants to be and shifts during the day between warming up, activity and cooling down. Without a gradient it cannot regulate its temperature, and digestion and immune defence suffer.

A gradient is built with the heat source at one end and a cooler area at the other. The terrarium must be large enough for the difference to arise: in a small terrarium the whole space becomes either too warm or too cold. Each species' guide gives the values for day, night and basking spot.

A single warm spot in an otherwise uniformly cool terrarium is not a gradient. The animal must be able to reach its preferred body temperature without lying on a scorching surface, and it must be able to shed the heat again. Hides at both the warm and the cool end are necessary: an animal that has hiding places only at the cool end has to choose between security and warmth.

The animal's behaviour is the best check. An animal that lies under the heat source all day is too cold. An animal that hides at the cool end and gapes or breathes rapidly is too hot. An animal that uses the whole terrarium and changes position regularly has a gradient that works.

Basking spot and hotspot

The basking spot is the warmest place in the terrarium, where the animal warms up to its active body temperature. The temperature is measured on the surface itself, where the animal lies, not in the air above it. It lies above the species' air temperature and is far higher in diurnal desert species than in nocturnal animals.

The temperature at the basking spot varies greatly between groups:

  • Nocturnal and crepuscular geckos from tropical forests, such as Correlophus ciliatus, need no more than 26-28 °C at the warmest spot.
  • Nocturnal geckos from dry regions, such as Eublepharis macularius, get a warm zone of 32-35 °C.
  • Diurnal geckos, such as Phelsuma grandis, get a basking spot of 32-35 °C.
  • Diurnal agamids from open, dry regions, such as Pogona vitticeps, get around 40-45 °C at the basking spot.
  • Monitors from dry regions, such as Varanus acanthurus, get 55-65 °C at the basking spot.

The basking spot should be a surface the animal can lie on: a flat stone, a thick branch, a piece of bark or a slate tile. A stone retains heat for a while after the lamp is turned off. It must sit stably so that it cannot topple over the animal, even when the animal digs.

The basking spot must be large enough for the whole animal to lie in the warmth, so that the whole body is warmed at once. If the lamp warms only a spot in the middle of the back, it is not good enough, and large lizards and snakes may need several heat sources. Heat rocks with a built-in heating element often cause burns and are not used.

Night-time drop

At night nature cools down, and the terrarium must follow. For many species a night temperature about 5 °C below the daytime temperature suits. This gives a natural daily rhythm, which also affects appetite, digestion and reproduction.

Tropical forest species have a moderate drop. Correlophus ciliatus gets 22-26 °C by day and 18-21 °C at night, Agalychnis callidryas 24-28 °C by day and 20-22 °C at night. Species from desert and mountains have a larger drop: Varanus acanthurus gets 20-24 °C at night after a basking spot of 55-65 °C by day, and Hoplodactylus duvaucelii from cool regions thrives at 10-16 °C at night and 15-25 °C by day.

At night the light must be turned off, as constant light disturbs rest. Bulbs that shine can therefore not be used as night heat. If heat is needed at night, it must come from a source without light, for example a ceramic heat emitter, a radiant heat panel, a heat mat or a heating cable.

If the room temperature at night is below the species' lower limit, the lightless heat source is controlled by a thermostat with a day and a night value. Many thermostats can be programmed so that the temperature is lowered automatically at set times. If the room already lies within the species' night range, it is enough to turn the heat off.

The night temperature for each species is in its guide, and it is just as important to get right as the daytime temperature.

Heat sources

The heat source is chosen according to the animal's way of life and the terrarium's size. Whatever the type, it must sit at one end of the terrarium so that a gradient arises, be shielded so that the animal cannot touch it, and be controlled by a thermostat.

  • Spot bulbs and incandescent bulbs give both light and heat and suit diurnal species that bask. They warm the surface under the bulb more than the air. They must not be on at night.
  • Ceramic heat emitters give heat without light, become very hot and can be used both day and night. They require a ceramic socket and can dry the air in small terrariums.
  • Heat mats and heating cables warm from below and suit ground-dwelling nocturnal animals, such as Eublepharis macularius, which take heat through the belly, but not as the only heat source for diurnal species that bask. The mat must not cover the whole bottom, so that the animal can always get away from the heat, and it must not be placed where the animal can dig down to it.
  • Radiant heat panels and heat panels give infrared heat without visible light and can be used as a basking spot and as night heat.
  • Mercury vapour and metal halide give heat, light and UVB from the same bulb and suit a basking spot in large terrariums for species in zones 3 and 4.

Several heat sources can be combined: a lamp for the basking spot by day and a lightless source for the base heat at night. Light and heat must be controllable separately, so that the heat does not disappear when the light goes out.

Read more: Lighting and UVB

Thermostats

A thermostat keeps the temperature stable by controlling the heat source according to a sensor. Without a thermostat the temperature varies with season and weather, and a fault can cause overheating. A thermostat is a safety measure, not a luxury accessory.

There are three main types.

  • On/off. Switches the heat source fully on or off around the set value, so that the temperature swings slightly up and down. It can control all heat sources, but suits sources without light best, such as heat mats, heating cables and ceramic heat emitters. A bulb that switches on and off flickers.
  • Dimming. Turns the output smoothly up and down and can control both bulbs that shine and heat sources without light. It is the obvious choice for spot bulbs and incandescent bulbs.
  • Pulse-proportional. Switches on and off in rapid pulses and keeps the temperature very stable, but only for heat sources without light, for example ceramic heat emitters, heat mats and heat panels.

UVB fluorescent tubes are not heat sources and are put on a timer, not a thermostat. For mercury vapour and metal halide, follow the manufacturer's instructions; the temperature at the basking spot is regulated here by the distance.

Check that the thermostat's maximum load in watts is higher than the heat source's, and that it can be set high enough: ordinary thermostats often go only to about 35 °C, while there are versions for hot basking spots. Place the sensor where the temperature is to be controlled: at the basking spot for a lamp and at the mat for a heat mat. The sensor must be fixed so that it does not move.

A thermostat can fail. An extra thermostat that cuts out at too high a temperature is the last safeguard.

Measuring and checking

You cannot control a temperature you do not measure. Have a thermometer at both the warm and the cool end, and read them daily.

Digital thermometers with an external sensor and min./max. memory are the most useful. The sensor is placed at the animal's height. A sensor at each end shows the gradient, and the memory shows how cold it gets at night and how warm it gets in the middle of the day. Small analogue dial thermometers are often imprecise; compare them with a digital one before use.

An infrared thermometer measures surface temperature without contact and is the best tool for checking the basking spot daily. It shows the temperature the animal feels on belly and back, but does not measure air temperature. Shiny surfaces such as metal and glass give wrong values, while matt surfaces such as stone and wood give the most reliable. Measure in several places, and point the meter directly at the surface.

A check chart helps: write down the temperature at the basking spot, in the middle, at the cool end and at night, the first time at start-up and then weekly and after every change. Deviations from the species guide are corrected by changing the heat source's distance, the bulb's wattage or the thermostat's setting.

The animal's behaviour is the final check. Posture, appetite and activity show whether the temperature is right, even when the instruments show what is expected.

Overheating and fire safety

Signs of overheating are an open mouth, rapid breathing or gasping, and restlessness in which the animal looks for a cooler place. Later the animal becomes lethargic and stops eating. Sores and burns on head, neck and back come from a basking spot that is too hot or too close, often in a terrarium where the rest is too cold, so that the animal stays too long under the lamp.

The typical causes are a thermostat that fails, a lamp hanging too close, and direct sunlight through a window. Never place a terrarium so that the sun shines directly into it: the glass acts as a greenhouse, and the temperature rises quickly. Do not place it near radiators or in a draught either.

Fire safety is about protecting both animals and home.

  • Use sockets and cables designed for the output and heat they are exposed to. Ceramic heat emitters and radiant heat panels must have ceramic sockets.
  • Keep distance from combustible materials, and follow the manufacturer's instructions.
  • Put a wire guard around heat sources that the animal can reach.
  • Connect all heat sources to a thermostat and preferably an extra fuse.
  • Never use a heat mat that is folded, damaged or covered with insulating material.
  • Check plugs, cables and sockets regularly for discoloration and wear, and pull the plug if anything smells burnt.

Monitoring the equipment is a fixed part of daily life, especially in terrariums that are heated around the clock.

Amphibians and animals that do not tolerate heat

Amphibians have thin, water-permeable skin and generally thrive at lower temperatures than reptiles. Salamanders and other newts and salamanders prefer lower temperatures than frogs. Most amphibians do well at 16-21 °C, while tropical species may need 24-27 °C. Outside the range in which they thrive, the immune system is weakened, and they more easily develop infections and nutritional diseases.

The species guide gives the exact limits: Oophaga pumilio gets 22-26 °C by day, Mantella aurantiaca 20-23 °C and Theloderma corticale 18-23 °C. Some reptiles from cool regions, such as Hoplodactylus duvaucelii with 15-25 °C by day, also require a cool room. In summer, living rooms and lofts can become far warmer, and a terrarium quickly becomes a greenhouse. Place terrariums for cool species in a cool room without direct sun and without heat sources nearby.

Amphibians seldom get a point heat source. A spot bulb dries out the skin and can cause burns. Fluorescent tubes or LEDs are used for lighting, because they give little heat, and any heat is given evenly and gently. Most species do not need a basking spot, but a weak gradient so that the animal can choose.

In summer, active cooling may be needed: good ventilation, a fan blowing over the terrarium, moving to a cooler room, air conditioning or a chiller for the water section. Measure more often in warm periods, preferably in the afternoon on the hottest days, and check the temperature with an infrared thermometer.

Species that need a cool period in winter are described in the theme on brumation.

Read more: Brumation and the seasons

Sources

  1. Management and Husbandry of Reptiles. Merck Veterinary Manual, 2026
  2. Environment and Husbandry for Amphibians. Merck Veterinary Manual, 2026
  3. Housing for Amphibians. Merck Veterinary Manual (pet owner version), 2026
  4. Guidelines for Inspection of Companion and Commercial Animal Establishments. Frontiers in Veterinary Science, 2018
  5. Pet Reptiles - Are We Meeting Their Needs?. Animals, 2021
  6. Ministat 100 Digital On Off Thermostat. Microclimate
  7. Dimmer B1 Digital Dimming Thermostat. Microclimate
  8. Pulse B2 Digital Pulse Thermostat. Microclimate
Found a mistake? Suggest a correction

Tell us what is wrong and what it should say. We read every suggestion and correct the page once we have checked it.