Humidity, misting and ventilation
How to measure, control and maintain moisture in a terrarium: hygrometers, daily rhythm, misting, foggers, air exchange, mould, shedding and water quality. For everyone who keeps reptiles and amphibians.
Moisture is a microclimate, not a single number
Humidity is given as relative humidity (RH) in per cent. It depends on temperature: warm air can hold more water vapour than cold, so relative humidity falls when a heat lamp comes on and rises again when it goes off. A single figure for the whole terrarium therefore says little, and the humidity figures in the species guides should be read as a range over the day and across the terrarium's zones.
The terrarium must have zones. At the warm, dry end humidity can be low, while a hide with damp moss or damp soil at the cool end is far higher. The animal chooses for itself. Both too low and too high humidity cause serious problems with skin and airways, and humidity is just as important as temperature.
Desert species such as Pogona vitticeps, Chondrodactylus turneri and Hemitheconyx caudicinctus need a dry terrarium with a dry, warm zone. Even so, desert species also need a humid hide: in the wild they find damp burrows and nightly dew, and in Eublepharis macularius and tortoises, for example, a humid microclimate prevents poor shedding and pyramiding of the shell.
Rainforest species such as Uroplatus fimbriatus and poison dart frogs need high humidity, but also periods when the terrarium dries out a little. Correlophus ciliatus and Tarentola mauritanica lie in between with moderate humidity, 50-80% and 50-60% respectively. Most amphibians thrive at 75-80% RH and tropical species at 85-90%. Always check the species' own guide. A desert terrarium that is misted often becomes too damp, and a rainforest terrarium with mesh over the whole top dries out.
Measuring with hygrometers
Every terrarium needs at least one hygrometer and one thermometer. Digital sensors with an external probe are far more reliable than the small, round dial gauges, which can read very wrongly and are slow to respond.
A hygrometer can be checked with a salt test. Place a small dish of table salt, moistened to a slurry with undissolved salt remaining, together with the sensor in a sealed container. The air above saturated salt water has a relative humidity of about 75%, and after a few hours the sensor should show that. If it shows a different figure, the difference can be subtracted, or the sensor replaced.
Place the sensor at the animal's height and away from the spray, the heat source and the fogger's outlet. In tall terrariums use two sensors, one near the bottom and one at the top, so that the difference between the layers can be seen. A terrarium for arboreal species such as Correlophus ciliatus is often drier at the top, where the lamp sits, than down at the bottom.
Also measure at different times. A reading in the middle of the day does not tell you what the night looks like. Digital sensors with min./max. memory show both the lowest and highest value of the day and are therefore a good choice.
Daily rhythm in humidity
In the wild, humidity follows a daily rhythm: it is highest at night and early in the morning when the air cools, and falls during the warmest hours of the day. Many tropical regions have heavy dew or rain at night and dry out during the day. A terrarium that imitates this is both more natural and less prone to mould, because plants and substrate get time to dry.
For species such as Phelsuma grandis and Agalychnis callidryas, a heavy misting late in the day or shortly before the lights go out suits, so that humidity rises at night and fades during the day. The specific figures are in the species guides.
For nocturnal species such as Uroplatus phantasticus and most other leaf-tailed geckos, it is the evening and night that count. Here misting is done shortly after the light goes out, or the timer is set for the night hours.
Let the terrarium dry partially between mistings. Constant saturation is not natural and promotes mould and bacteria. A substrate that is wet around the clock is a sign that there is too much misting or that the water cannot drain away.
Misting: hand sprayers and rain systems
An ordinary hand sprayer with a fine mist can cover small and medium-sized terrariums. Spray on leaves, the back wall and furnishings so that animals that drink droplets can reach them. This applies especially to Furcifer pardalis and other chameleons, which drink almost only droplets from leaves and often become dehydrated if they do not get them. Many day geckos also lick dew and raindrops.
A rain system with nozzles at the top, a pump, a timer and a water reservoir gives regular, uniform misting, even when you are away. The number and length of mistings depend on the species and the terrarium's ventilation; begin with short mistings, and adjust according to the hygrometer and how quickly the terrarium dries. Drainage and a drainage layer must be able to take the water, otherwise the substrate becomes a puddle. A drip system, where water drips down onto leaves, is a simple alternative for species that drink droplets.
Pump, tubing and nozzles must be cleaned regularly of limescale and deposits, and the nozzles clog quickly with hard water. Spray bottles and other moisture equipment are disinfected weekly, because bacteria otherwise grow in them and are spread with the mist.
Never spray directly into an animal's eyes. If the droplets stay on the leaves for many hours, the ventilation is too weak.
Foggers and humidifiers
Ultrasonic foggers produce a cold mist and can keep humidity high in a sealed terrarium. They are used especially for amphibians and rainforest species, for example poison dart frogs such as Oophaga pumilio. Moisture can also be provided with small streams and waterfalls, with a moist substrate and with live plants.
Foggers have their risks. The mist carries the contents of the water with it: limescale becomes white dust on glass and leaves, and bacteria from the reservoir are spread in the air. The reservoir must therefore be kept clean and disinfected at least weekly, and the water must be clean. Limescale-free water prevents the dust.
Dense and persistent mist causes condensation and stagnant, saturated air, precisely the conditions in which mould and bacteria thrive. A fogger should therefore run on a timer and for short periods, not around the clock, and only in terrariums with good airflow.
The animal must always be able to retreat to a drier zone, and a small terrarium with no escape must not be filled with mist. Watch the animal in the first days after a fogger is installed: an animal that moves away from the mist or sits damp around the clock is getting too much of it.
Ventilation and stagnant air
Humid air requires air exchange. Terrariums for amphibians need about 1-2 air changes per hour. Turning down the ventilation to retain heat and moisture is a bad idea and often causes skin and respiratory disease in reptiles.
Ventilation must run across the terrarium: openings low on one side or in the front and high on the other side or in the top, so that cool air is drawn in below and warm, humid air escapes above. Even when the whole top of a glass terrarium is mesh, the air exchange can be very poor, and it is precisely in the lower layers, where substrate and plants are dampest, that the air stands still.
Signs of too little ventilation are condensation on the glass for many hours, smell, mildew in corners and on wood, and water beads on the leaves well into the day. Signs of too much are a substrate that dries out quickly and humidity that drops sharply after each misting. If that is the case, the openings can be made smaller, but not closed, or misting can be done more often.
A small, quiet fan behind a mesh can keep air moving in large, sealed rainforest terrariums. It should run gently so that it does not dry out the terrarium.
Mould and mildew
Mould appears where moisture and stagnant air meet organic material. Typical places are corners, the back wall, cork and wood, humid hides and the substrate in poorly drained terrariums. White, threadlike fungus on new substrate and new wood often disappears of its own accord when the moisture dries out; green, black or slimy coatings require action.
Remove the affected material, wash the furnishings in hot water, and let them dry. Give the terrarium more ventilation, and mist less. Find the cause: is water standing, is ventilation too weak, or are there too many food remains on the substrate?
In bioactive terrariums, springtails and woodlice help keep fungus down, but they do not replace ventilation and dry periods. See the theme on terrarium construction.
For cleaning, soap and water are often enough. Bleach can be used for disinfection, for example 30 ml ordinary household bleach per litre of water for at least 30 minutes, but everything must be rinsed thoroughly and preferably dry before the animal returns. Disinfectants containing phenol are toxic and must not be used. Equipment for misting and fog is disinfected weekly.
Read more: Feeder animals: keeping and breeding Read more: Quarantine and hygiene
Shedding and dehydration
Too low humidity causes poor shedding (dysecdysis): skin remnants stay on toes, tail and around the eyes. Humidity is especially important in the days before a shed, when the need is far greater than usual. In Eublepharis macularius and Hemitheconyx caudicinctus, a humid hide with moss or damp vermiculite helps. Skin remnants on the toes can constrict and cut off the toe, so toes and tail tip must be checked after every shed.
Signs of dehydration are sunken eyes, wrinkled or slack skin and infrequent or very hard droppings. In chameleons, which drink only droplets, dehydration is one of the most common problems if they do not get rain or dew. Some reptiles drink from a water dish, others only droplets from plants and furnishings; the species guide says which kind the animal is.
Amphibians absorb water through the skin and can dry out in a short time. An animal that is drying out is best helped with higher humidity and access to clean water. A dull animal that sits inactive may be at the beginning of dehydration.
Constantly high humidity causes other problems: skin infections and respiratory disease. If the animal's condition is unclear, contact a vet with experience of reptiles or amphibians.
Water quality: chlorine, limescale and reverse-osmosis water
The water in sprayers, rain systems and foggers ends up on the animal, on the plants and in the animal's mouth. Amphibians' skin absorbs water readily and thus also toxins, so the water must be free of chlorine, ammonia, nitrite, pesticides and heavy metals.
Chlorine is removed by letting the tap water circulate through a carbon filter for at least a day. If the water contains chloramines, an agent that breaks the bond, for example sodium thiosulphate, must be used first, followed by filtering. The waterworks can say how the water is treated and how hard it is. Bottled water should be chosen according to the label.
Hard water causes white deposits on glass and leaves and clogs nozzles and pumps. Limescale-free water, for example reverse-osmosis (RO) water, prevents this and is well suited to rain systems and foggers. Distilled water must not be used for amphibians, and reverse-osmosis water is almost as pure. It should therefore not be used alone as drinking and bathing water for amphibians, but can be mixed with treated tap water.
Change the water in water dishes and containers daily, or more often if it is dirty, and clean containers, tubing and nozzles regularly. In water sections with a filter, test the water weekly for temperature, pH, hardness, ammonia, nitrite and nitrate.
Sources
- Environment and Husbandry for Amphibians. Merck Veterinary Manual (professional version), 2026
- Housing for Amphibians. Merck Veterinary Manual (pet owner version), 2026
- Management and Husbandry of Reptiles. Merck Veterinary Manual, 2026
- Diapausing Cavity-Nesting Bees (Osmia, Megachile) Resist Winter Desiccation Stress. Insects, 2025